User manual

SD7K User’s Manual
digital drum kit
12
Press the [UTILITY] button to enter the Utility Mode. Now the [UTILITY] button
will page through the Utility menu.
In the UTILITY Mode, you can adjust the trigger parameters (gain, crosstalk, curve) for each pad,
as well as the rim sensitivity of the snare pad and the splash sensitivity of the hi-hat control pedal.
Those parameters are common to all kits.
In the Trigger Gain page, the rst digit of LED will display letter ‘E’, which is followed
by the gain value (1~16, not looped). Greater gain will allow you to trigger a signal
even if you strike a pad lightly.
In the Rim Sensitivity page, rim sensitivity of the dual trigger snare pad can
be adjusted to balance the head-rim velocities. The lowest digit will show the
rim sensitivity level (1~8) of current pad with letters ‘rE’ displayed on the rst
two digits of the LED. A bar will be shown instead of the sensitivity level if
rim triggering is not supported by the currently selected pad (any other pad
than the snare).
In the Trigger Crosstalk page, the last 2 digits will show the crosstalk value (1~16) of the
current pad with a letter ‘o’ displayed on the rst digit of the LED. Hitting one pad may
trigger the sound from another pad unintentionally. This effect can be eliminated by
setting this parameter to a higher value on the pad that is mistriggering.
Pad sensitivity (gain)
rim sensitivity
crosstalk
Utility menu
The current pad to be adjusted can be selected either
by pressing its Pad Select button, or by striking the pad
itself. The Pad Select indicator lights up to show which
pad is currently selected.