User's Manual

User Manual of CPE-0001
-15-
This chapter will show you how to configure the basic functions of your Wireless Router using Quick Setup
within minutes.
A computer with wired Ethernet connection to the Wireless Router is required for the first-
time configuration.
4.1 Manual Network Setup - TCP/IPConfiguration
The default IP address of the Wireless Router is 192.168.0.1 and the default Subnet Mask is 255.255.255.0.
These values can be changed as you desire in the web UI of the Wireless Router. In this section, we use all the
default values for description.
Whether the Wireless Router is configured via wired or wireless connection, the PC needs to be assigned an IP
address first. Before you connect the local PC to the Wireless Router via wired or wireless connection, please
configure the IP address for your PC in the following two ways first.
 Obtaining an IP addressautomatically
 Configuring the IP addressmanually
Inthefollowingsections,we’llintroducehowtoinstallandconfiguretheTCP/IPcorrectlyinWindows7.Andthe
procedures in other operating systems are similar. First, make sure your Ethernet Adapter is working, and refer
to the Ethernet adapter’s manual ifneeded.
4.1.1 Obtaining an IP AddressAutomatically
Summary:
1. Set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on yourPC.
2. Then the Wireless Router built-in DHCP server will assign IP address to the PCautomatically.
If you are sure the DHCP server of Wireless Router is enabled, you can set up the TCP/IP Protocol in "Obtain
anIPaddressautomatically"modeonyourPC.AndthentheWirelessRouterbuilt-inDHCPserverwillassign an IP
address to the PCautomatically.
1. Installing TCP/IPComponent
1) On the Windows taskbar, click the Start button, point to Control Panel, and then clickit.
Chapter4. Quick InstallationGuide