User's Manual

SDM630 DMR TIER II – OPERATING INSTRUCTIONS

1. INTRODUCTION

1.1 O

VERVIEW

The SDM600 Series Radios are versatile Digital Signal Processor (DSP) controlled, two-way

mobile radios. The SDM600 Series is available in a number of frequency bands and

versions for specific applications. These Operating Instructions describe the operation of the

DMR Tier II Standard compliant Mobile Radio, consisting of an SDM600 Transceiver and

SDM630 Control Head.

The radio is software programmable and it can be customised to the operational

requirements of your particular fleet. Your Simoco representative can help in programming

your radio facilities to meet your present and future requirements.

1.2 C

ONFIGURATION

The SDM630 Radio must be configured using the Field Personality Programmer (FPP) prior

to operation. The configuration process defines the radio channels, signalling and other

settings so that the radio will operate with your system

1.3 I

NSTALLATION

As the installation of your SDM600 Transceiver is a technical and possibly hazardous

operation, we recommend that it is installed and set up for use by your dealer or an

authorised installer. However, if you need information regarding the correct procedures for

installation, please refer to the SDM600 Series Installation Instructions supplied with the

radio.

1.4 M

ODES OF

PERATION

The SDM630 Radio is capable of operation in Analogue FM and DMR modes.

Radio Channels are organised in groups of up to 250 per zone. Up to 40 zones may be

defined.

Generally, zones can be programmed with channels belonging to common function groups.

A radio channel can be defined as either Analogue or DMR, and a Zone may contain a mix of

Analogue or DMR Channels.