User's Guide
Table Of Contents
- INTRODUCTION
- CONTROLS
- MENU SYSTEM
- MENU SCREENS
- Channel Screen
- Menus
- Zone
- Squelch
- Mute Adjust / Monitor
- Phonebook
- Phonebook Edit
- User Options
- Contrast
- Alert Volume
- Radio Info
- Mode
- RSSI
- Crypto
- Setup
- Stored Calls
- Messages
- Messages Selection Pop-Up Menu
- View Received Messages Screen
- Message View Pop-Up Menu
- More Message View Screen
- Reply Message Selection Pop-Up Menu
- Short Message Reply
- Text Message Reply Screen
- Send Message (Short or Text)
- Text Message Screen
- Destination Select Pop-Up Menu
- Phone Book Selection Screen
- Enter Unit ID Screen
- Scan Edit Menu
- No Menu
- COMMON FUNCTIONS AND FACILITIES
- SPECIAL FUNCTION KEYS
- ALERT TONES AND MESSAGES
- GLOSSARY
- COMPLIANCE WITH RF ENERGY EXPOSURE GUIDELINES
SRP9100 RADIO P25 – OPERATING INSTRUCTIONS
Press the “OK” key for the “Alert Volume” adjustment screen
Use the ▼ and ▲ keys to change the relative alert volume level. The beep will sound at the
indicated level each time the setting is changed.
Press OK to accept the setting and return to the Channel Screen.
Pressing the M key will exit back to the setup menu.
Note: A minimum Alert Level may be set by the FPP to ensure the Alerts can always be
heard from the speaker.
4.2.9 Radio Info
These screens display information that identifies the Field Programmer File description,
Radio ID, Serial Number, Software Version and IP Address.
From the Settings Sub Menu, step through the menu options with the ▼ and ▲ keys until the
Radio Info menu is displayed.
Press the “OK” key for the “Radio Info” Screen.
The ▼ and ▲ keys select the following information pages:
P25 Conv. ID and Radio Band
Radio Software Version and Serial Number
© TMC Radio 2007 Page 25 TNM-U-E-0073 1.1b