User's Guide
Table Of Contents
- INTRODUCTION
- CONTROLS
- MENU SYSTEM
- MENU SCREENS
- Channel Screen
- Menus
- Zone
- Squelch
- Mute Adjust / Monitor
- Phonebook
- Phonebook Edit
- User Options
- Contrast
- Alert Volume
- Radio Info
- Mode
- RSSI
- Crypto
- Setup
- Stored Calls
- Messages
- Messages Selection Pop-Up Menu
- View Received Messages Screen
- Message View Pop-Up Menu
- More Message View Screen
- Reply Message Selection Pop-Up Menu
- Short Message Reply
- Text Message Reply Screen
- Send Message (Short or Text)
- Text Message Screen
- Destination Select Pop-Up Menu
- Phone Book Selection Screen
- Enter Unit ID Screen
- Scan Edit Menu
- No Menu
- COMMON FUNCTIONS AND FACILITIES
- SPECIAL FUNCTION KEYS
- ALERT TONES AND MESSAGES
- GLOSSARY
- COMPLIANCE WITH RF ENERGY EXPOSURE GUIDELINES
SRP9100 RADIO P25 – OPERATING INSTRUCTIONS
From the Channel Screen, select menu mode with the “M” or “Menu” key and step through
the menus with the ▼ and ▲ keys until the “Mode” menu is reached.
Press “OK” to select the Mode menu.
From the “Mode” menu, use the ▼ and ▲ keys to select the required operating mode, such
as APCO P25, PMR or MPT Trunking. While the required mode is displayed, press OK to
select that operating mode. The radio will then display the default screen for that mode.
Keypad shortcuts can be used to change modes from the keypad.
PMR (*60#)
P25 (*80#)
MPT Network 1 (*71#)
MPT Network 2 (*72#)
4.2.11 RSSI
This screen displays the received signal strength in dBm. The reading is typically accurate
within +/- 2 dBm between -120 and -80dBm, when the radio has been correctly calibrated.
For example, -90dBm is a strong signal and –120dBm is no signal.
The screen also shows the Bit Error Rate (BER) on digital channels. RSSI and BER are
typically used to indicate signal quality.
From the Settings Sub Menu, step through the menu options with the ▼ and ▲ keys until the
“RSSI” menu is displayed.
© TMC Radio 2007 Page 27 TNM-U-E-0073 1.1b