User's Guide
Table Of Contents
- INTRODUCTION
- CONTROLS
- MENU SYSTEM
- MENU SCREENS
- Channel Screen
- Menus
- Zone
- Squelch
- Mute Adjust / Monitor
- Phonebook
- Phonebook Edit
- User Options
- Contrast
- Alert Volume
- Radio Info
- Mode
- RSSI
- Crypto
- Setup
- Stored Calls
- Messages
- Messages Selection Pop-Up Menu
- View Received Messages Screen
- Message View Pop-Up Menu
- More Message View Screen
- Reply Message Selection Pop-Up Menu
- Short Message Reply
- Text Message Reply Screen
- Send Message (Short or Text)
- Text Message Screen
- Destination Select Pop-Up Menu
- Phone Book Selection Screen
- Enter Unit ID Screen
- Scan Edit Menu
- No Menu
- COMMON FUNCTIONS AND FACILITIES
- SPECIAL FUNCTION KEYS
- ALERT TONES AND MESSAGES
- GLOSSARY
- COMPLIANCE WITH RF ENERGY EXPOSURE GUIDELINES
SRP9100 RADIO P25 – OPERATING INSTRUCTIONS
5.1.4 Receiving (Single Channel Screen)
The Speaker Icon
will show when a valid signal is being received and audio will be heard
at the Loudspeaker.
The icon will be shown as an outline when a signal is being received that is not addressing
this radio and hence, is not audible. For instance, another user group may be having a
conversation on another talkgroup when receiving in Selective Mute.
The analogue channel’s receive mute setting can be altered from the Mute Adjust menu.
While on an Analogue channel, both P25 and Analogue FM transmissions will be received.
While on a P25 channel, only P25 transmissions will be received.
To change channels, press the ▼ and ▲ keys while in the channel screen.
Zones can be changed from the Zone menu, see Section 4.3.1
5.1.5 Received Individual Calls
Unanswered received Individual calls addressed to the radio are stored in radio memory.
The caller Unit ID may be viewed, answered and deleted by the user as desired.
A newly received individual call addressed to the radio sounds an alert tone periodically until
the user presses any key.
If the caller unit ID of a newly received unanswered call is already in the Stored Calls list, the
old Stored Call record of that unit ID will be replaced by the new record and added to the top
of the list.
To view/answer/delete received call records, the Stored Calls screen is selected.
© TMC Radio 2007 Page 43 TNM-U-E-0073 1.1b