User's Guide

Table Of Contents

SRP9100 RADIO P25 – OPERATING INSTRUCTIONS

If “DELETE” is selected, pressing “OK” removes the selected call record (being viewed) from

the list. The radio returns to the Stored Calls Screen with the next record being displayed.

If “CANCEL” is selected, the Stored Calls screen is displayed.

If “CALL” is selected, pressing “OK” sets the radio to individual calling mode with the ID of

the stored call. A subsequent PTT within the configured time interval will send an individual

call to the ID of the stored call.

5.1.8 Transmitting

To avoid interfering with other users of the channel, listen first, or check that the “speaker”

icon is not present, to ensure no transmissions are occurring.

If the speaker icon is shown, there are transmissions present on the channel and the user

should not transmit. The radio may be programmed to prevent transmission on a busy

channel if required.

Hold the portable approximately10 centimetres from the mouth, press the “Press to talk”

(PTT) switch and note that the TX-LED is RED. Wait for the grant tone, and then speak

clearly across the face of the microphone in a normal conversational manner.

In most systems it is important to wait a short time between pressing PTT and commencing

to speak. This ensures that the path is properly established and avoids lost or distorted

speech.

Use the correct operating procedure and keep transmissions short.

Release the PTT switch as soon as the message is finished.

The talk group for a transmission is usually associated with a channel selection. A talk group

will address all others that have the same TGID selected.

While on a P25 Channel, the transmission will be P25 digital. For an Analogue channel, the

transmission will be Analogue FM

Note: A Transmit Limit Timer may be setup that limits a continuous transmission on a

channel. The last 10 seconds before the timer expires may be accompanied by warning

beeps.

5.1.9 Scan/Vote Functions

The Scan/Vote Function allows the sequential searching of up to 16 channels if the selected

zone channel is programmed as a Scan channel, and 15 channels if the selected zone

channel is programmed as a Vote channel, for a valid signal (Carrier + CTCSS / DCS tone

for Analogue FM or Network Access Code for P25). When found, the radio will stop on that

channel until the signal disappears again.