User's Guide
Table Of Contents
- INTRODUCTION
- CONTROLS
- MENU SYSTEM
- MENU SCREENS
- Channel Screen
- Menus
- Zone
- Squelch
- Mute Adjust / Monitor
- Phonebook
- Phonebook Edit
- User Options
- Contrast
- Alert Volume
- Radio Info
- Mode
- RSSI
- Crypto
- Setup
- Stored Calls
- Messages
- Messages Selection Pop-Up Menu
- View Received Messages Screen
- Message View Pop-Up Menu
- More Message View Screen
- Reply Message Selection Pop-Up Menu
- Short Message Reply
- Text Message Reply Screen
- Send Message (Short or Text)
- Text Message Screen
- Destination Select Pop-Up Menu
- Phone Book Selection Screen
- Enter Unit ID Screen
- Scan Edit Menu
- No Menu
- COMMON FUNCTIONS AND FACILITIES
- SPECIAL FUNCTION KEYS
- ALERT TONES AND MESSAGES
- GLOSSARY
- COMPLIANCE WITH RF ENERGY EXPOSURE GUIDELINES
SRP9100 RADIO P25 – OPERATING INSTRUCTIONS
To activate Scanning, select a channel that has been programmed as a Scan channel. Once
selected, the scanning will either start automatically, if programmed, or you will need to press
the programmed scan function button. (Field Programmer configurable).
If a selected zone channel is programmed as a Vote channel, the voting will start
automatically without any other user intervention.
While listening on the channel, the user is able to PTT on that channel. After the signal
disappears, the radio will remain listening on the channel for a short time (Field programmer
configurable, typically 3 seconds) before resuming scanning or voting
If a Priority Channel is assigned to Scan mode, the radio will interleave a check of this
channel between each normal Scan channel.
5.1.9.1 Scan/Vote Screen
Scan can be started by
(1) Pressing the function key that has been assigned the scan function
by the Field Programmer or
(2) Selecting a zone channel that has been assigned to automatically
scan by the Field Programmer, or
(3) Under User Options menu, selecting the SCAN ON option.
Selecting a channel that is associated to a VOTING group, with Scan/Vote
enabled in the FPP, starts voting.
The top line of the display still shows the name of the current selected channel. The second
line of the display shows the name of the current selected zone while scanning/voting.
The Channel can be changed by using the ▼ and ▲ keys. Other channels may be either
Scan or Normal channels, depending on the radio’s configuration.
Scanning/Voting is indicated by a rotating arrow symbol.
When stopped on a channel, the second line from the top shows the name of the channel
from the scan group that the radio stopped on. If stopped on a channel, that channel can be
“skipped” by pressing the skip programmed function key. Once a channel is “skipped” it will
not be scanned for the duration that Zone/Channel selection.
When transmitting on a channel, the second line of display shows the name of the current
channel that the radio is transmitting on.
5.1.10 Keypad Lock
The Keypad Lock function prevents accidental key presses.
© TMC Radio 2007 Page 46 TNM-U-E-0073 1.1b