Service Manual

Page 3.32
2 ~ SERVICE PHILOSOPHY
Remove the Speaker and Microphone
(1) Remove the speaker retaining clip.
(2) Lift the speaker / microphone assembly away from the front casing taking care not to damage the flexi-
circuit.
Figure 3 Removal of Speaker and Microphone
Remove the MMI PCB
The MMI PCB is held in place by four plastic lugs on the front casing.
(1) Using a small flat bladed screwdriver, exert slight sideways and upwards pressure on the edge of the
PCB (close to one of the top retaining lugs) whilst exerting slight outward deflection of the casing side
walls (A). This will release the PCB from the retaining lugs.
(2) Lift the MMI PCB and LCD display assembly away from the front casing.
Figure 4 Removal of MMI Assembly