Service Manual

ManualsBrandsSimoco Australasia ManualsElectronicsUHF Portable Transceiver

Page

5.1

6 ~ CIRCUIT DIAGRAMS

TNM-M-E-0012 Issue 1.23

5. ALIGNMENT (LEVEL 3 SERVICE ONLY)

This procedure is applicable to all versions of

SRP9100

portable transceivers.

If the radio contains customer configuration data that must be retained, you

must

first

use the SRM/SRP

Personality Programmer (FPP) software to read all radio configuration files and save them on to alternative

media

before

commencing the alignment procedure.

When the Alignment is completed, use the FPP software to retrieve this stored data and write it back to the

radio.

It is preferred that the radio remain installed in its cast and ABS case so that appropriate shielding and

battery supply are maintained.

Note. Final Tx power adjustments must be performed with the radio board installed in the chassis.

5.1 TEST EQUIPMENT

1. Radio transceiver test set CMT, 52/82 or similar.

Note. For alternative equipment, the

Mod Balance test requires internal DC

coupling between the demodulated

signal and demodulation output

connector.

2. Variable DC power supply 6.4V to 9.6V at 2.5 amps

3. Oscilloscope 20 MHz bandwidth minimum

4. SRP9100 Programming & Alignment Lead P/N PA-PRLD

5. SRP9100 Radio Test Interface Unit OR

See simple interface circuit in Fig 5.1

P/N PA-RTIU

6. Personal Computer 486 DX 66 or better.

Operating system Windows 95 or later.

Minimum RAM - 16MB.

5MB free hard disk space.

Floppy drive - 1.44MB.

Mouse and serial port required

7. SRM/SRP Alignment Tool Computer Software file

8. SRM/SRP Field Personality Programmer

(FPP)

Computer Software file

9. SRP9100 Simulated Battery

10. Antenna Adaptor for Portable PA-ACON

Caution

Preparing the radio for alignment will erase from the radio all customer PMR and Trunking

configuration data (channel, signalling information etc). The only data retained by the Alignment

Tool is the factory alignment data for the radio (DAC settings for Tx power, front-end tuning etc).

Using the Alignment Tool will allow changes to the original factory alignment and will invalidate

all warranties and guarantees unless performed by an authorised level 3 service centre.