User's Guide
Table Of Contents
- INTRODUCTION
- CONTROLS
- MENU SYSTEM
- MENU SCREENS
- Channel Screen
- Menus
- Zone
- Squelch
- Mute Adjust / Monitor
- Phonebook
- Phonebook Edit
- User Options
- Contrast
- Alert Volume
- Radio Info
- Mode
- RSSI
- Crypto
- Setup
- Stored Calls
- Messages
- Messages Selection Pop-Up Menu
- View Received Messages Screen
- Message View Pop-Up Menu
- More Message View Screen
- Reply Message Selection Pop-Up Menu
- Short Message Reply
- Text Message Reply Screen
- Send Message (Short or Text)
- Text Message Screen
- Destination Select Pop-Up Menu
- Phone Book Selection Screen
- Enter Unit ID Screen
- Scan Edit Menu
- No Menu
- COMMON FUNCTIONS AND FACILITIES
- SPECIAL FUNCTION KEYS
- ALERT TONES AND MESSAGES
- GLOSSARY
- COMPLIANCE WITH RF ENERGY EXPOSURE GUIDELINES
SRP9100 RADIO P25 – OPERATING INSTRUCTIONS
The “M” or “Back” key returns to Destination Selection pop-up Menu screen.
A “Reset” function key press (if configured), takes the radio back to the default screen
display.
Pressing “OK” sends the message to the entered unit ID (providing it is valid). The screen
will return to the default screen.
If the entered unit ID is not valid, or the IP address is not defined, an error beep will sound.
Sending a short message or text message can fail if the destination radio is not available.
4.2.16 Scan Edit Menu
This menu allows channels in Scan Groups to be added or deleted by the user.
Add and Delete changes to a Scan Group are stored permanently in the radio.
4.2.16.1 Scan Group Edit Screen
When selected, the “Scan Group Edit” screen is displayed, which shows the channels within
the Scan Group.
The second line from the top shows the name of the selected channel in the scan group.
The next line shows the channel type, i.e., “Member” if it is a normal member of the scan
group; “Priority” if it is the priority channel; or “Skipped”, if the channel is currently skipped
from the scan group.
The ▼ and ▲ keys select the channel from the scan group list..
When “Reset” function key is pressed (if configured), the radio returns to the default screen
display.
When the “Back” key or “Menu” is pressed, the radio returns to the “Scan Group Edit”
screen.
When “OK” key is pressed, a pop-up action selection menu is displayed.
© TMC Radio 2007 Page 39 TNM-U-E-0073 1.1b