User Manual

SGD-SB2025NT-TUM, Part 2
Jan 12 Page 51 SOLAR COMMISSIONING
More than one item may be changed at a time but the action must be completed by clicking ‘Apply’.
At this point any new setting or text will turn Blue until full confirmation is received from the
opposing end of the system. For text labels this will take several minutes as text is given lowest
priority in the supervisory process.
Table 2. Isolated O/P Functions in ‘Auto’ mode.
Relay O/P Central NI Station NI
#1 Voted signal present Tx Key (PTT)
#2 System/Channel Alarm ON No function assigned
#3 No function assigned No function assigned
Note.
For FW Config builds other than the standard 0x7FFFF, the Auto modes may produce
a different operation to that shown in Table 2. See Section 15 – Firmware Extensions
for more information.
5.2.3 Facilities
The ‘NI Engineering – Facilities’ page provides access to: the NI text label ‘Name’; the selection of
the signals presented to the GPS module; the setting of the ‘Test Tone’ frequency and level; and
the ‘CTCSS Tone’ level.
The ‘Facilities’ page of the NI Engineering facility is shown below in Figure 44 .
Figure 44. NI Engineering – Facilities page.
When viewing this page through the NI ET (as in Figure 44 above), there is facility for setting NI
alarms that is not visible; this is only presented on the TM ET – see Section 12 – Alarms for full
details of this function.