User Manual

SGD-SB2025NT-TUM, Part 2
Jan 12 Page 73 DIAGNOSTICS
Figure 63. Setting for Duplicated (Primary).
Note.
If an IP address is entered that is the same as one already actively in use anywhere on
the TM this will be cleared back to 0.0.0.0 when ‘Apply’ is clicked.
The ‘Duplication Status’ text will now change to reflect the duplication setting and the colour of the
indicator will show the status – see Section 8.2.4 below.
8.2.3 Duplicated (Secondary)
This option specifies that this TM will be operating in a duplicated environment and that it is
designated as a Secondary TM.
To configure a TM to operate as a Primary, carry out the following:
1. Open the TM Status panel and select the ‘Network’ button (see Section 4.3 – Setting the
TM IP Address ). The ‘TM Network Setup’ page shown below in part in Figure 64 will open.
Figure 64. Setting for Duplicated Secondary.
2. On the ‘TM Network Setup’ page, carry out the following:
2.1. Select the ‘Eng’ button.
2.2. Using the drop-down list, set the TM Duplication to ‘Duplicated (Secondary)’.
2.3. Tick the ‘IP Address 1’ box, which is now active.
2.4. Enter the IP address of the first Primary TM.