User Manual

SGD-SB2025NT-TM, Part 2
Jan 12 Page 105 APPENDIX A
APPENDIX A
SOLAR CONFIGURABLE SETTINGS
The intention here is to list the user configurable settings of a Solar network in alphabetical order
and to indicate which ET has access to which. The precursor to any change is likely to need
selection of an engineering mode and the conclusion being that the change needs to be applied
(see the relevant section in the handbook for full details).
Many of the settings are accessible from either the TM ET or the NI ET and this is indicated by the
text ‘Both ET’ in the ‘ET’ column. As a Solar 2 unit may have either a TM or an NI or both fitted as
main modules and that the GPS and the Environment I/O sub-modules may be accessed through
the ET appropriate to the unit build, then these settings are shown as ‘Either’. A setting that is
available to only one of the ETs is indicated by the text ‘TM ET’ or ‘NI ET’ as appropriate. Any
further information is noted where applicable.
The ‘Type’ column indicates the nature of the setting by using the following notation:
• ‘Button’ – click in or out to enable/disable or set on/set off etc.
• ‘Check’ – check the box to enable, un-check the box to disable.
• ‘Click’ – single (momentary) action to instigate function.
• ‘Drag/drop’ – the selection is made using a ‘Drag and drop’ operation.
• ‘Enter’ – the user must enter a value (usually validated) or character string (not usually
validated).
• ‘Select’ – select the option from a pull-down list (fixed choice).
• ‘Slider’ – the setting is adjusted by dragging a slider to the required position/level.
Table A1. List of ET Settings.
Topic Description Options/Notes Type Location (ET page) ET
Alarms
Configuration and
acknowledgement of
alarm events
Enable/Disable alarm
events & acknowledge
alarms
Button
Alarms (alarms
button, TM Tab)
TM ET
Audio In
Set audio I/P – fine
level
Approx 6 dB range Slider
NI Engineering (Main
audio tab)
Both ET
Audio In
Set audio I/P – coarse
level
0 to −18 dB, then −20
to −32 dB (6 dB steps)
Slider
NI Engineering (Main
audio tab)
Both ET
Audio In In route Normal/Inverted Button
NI Engineering (Main
audio tab)
Both ET
Audio In Enable 2.6 kHz LPF On/Off Check Setup (Misc tab) Both ET
Audio Out
Set audio O/P – fine
level
Approx 6 dB range Slider
NI Engineering (Main
audio tab)
Both ET
Audio Out
Set audio O/P –
coarse level
0 dB to −21 dB (3 dB
steps)
Slider
NI Engineering (Main
audio tab)
Both ET
Audio Out Out route Normal/Inverted Button
NI Engineering (Main
audio tab)
Both ET
Channel
Allocation
Relations: allocate
each NI to a channel
Associate any to any Drag/drop
Relations (Relations
button, TM tab)
TM ET
Channel
Facilities
Channel Name:
identify channel
Up to 20 characters
text
Enter
Channel Setup (Setup
button, channel tab)
TM ET