Material Safety Data Sheet
NH-20180927011 Issue date: 2018-09-27 Page 4 of 7
Splash contact
Material: Nitrile rubber
Minimum layer thickness:
0,2 mm
Break through time: 38 min
test method: EN374
If used in solution, or mixed with other substances, and under conditions which differ from EN 374,
contact the supplier of the CE approved gloves. This recommendation is advisory only and must
be evaluated by an industrial hygienist and safety officer familiar with the specific situation of
anticipated use by our customers. It should not be construed as offering an approval for any
specific use scenario.
Body Protection
impervious clothing, Flame retardant antistatic protective clothing., The type of protective
equipment must be selected according to the concentration and amount of the dangerous
substance at the specific workplace.
Respiratory protection
Where risk assessment shows air-purifying respirators are appropriate use a full-face respirator
with multi-purpose combination (US) or type ABEK (EN 14387) respirator cartridges as a backup
to engineering controls. If the respirator is the sole means
of protection, use a full-face supplied air
respirator. Use respirators and components tested and approved under appropriate government
standards such as NIOSH (US) or CEN (EU).
Control of environmental exposure
Prevent further leakage or spillage if safe
to do so. Do not let product enter drains.
SECTION 9: Physical and chemical properties
9.1
Information on basic physical and chemical properties
a)
Appearance
Form: liquid, clear
Colour: colourless
b)
Odour
No data available
c)
Odour Threshold
No data available
d)
pH
No data available
e)
Melting point/freezing
point
-144,0 °C
f)
Initial boiling point and
boiling range
78,0 -
80,0 °C
g)
Flash point
14,0 °C
-
closed cup
h)
Evaporation rate
No data available
i)
Flammability (solid, gas)
No data available
j)
Upper/lower
flammability or
explosive limits
Upper explosion limit: 19 %(V)
Lower explosion limit: 3,3 %(V)
The selected protective gloves have to satisfy the specifications of EU Directive 89/686/EEC and
the standard EN 374 derived from it.
Full contact
Material: butyl-rubber
Minimum layer thickness: 0,3 mm
Break through time: 480 min
Safety Data Sheet