Unit installation

Digital Half Cylinder
Page 6
4.0 Battery Warnings
4.1 Half Cylinder
Warning level 1 for main battery
If the main battery of the half cylinder goes empty, eight short signal tones, coming
quickly one after another, sound after you operate the transponder and before the
cylinder couples. You must replace both batteries now.
Warning level 2 for backup battery (SW Version 10.0 & SW Version 10.1)
In addition to the main battery warning, an additional sixteen short signal tones,
coming quickly one after another, sound for the backup battery warning. The cylinder
does not couple until after the signals. From now on, the backup battery is active. You
must replace both batteries as soon as possible.
Warning level 2 for backup battery (SW Version 10.2 and later)
In addition to the main battery warning, the signal tones of the backup battery warning
now sound for approximately 30 seconds. The cylinder does not couple until after the
signals. From now on, the backup battery is active. You must replace both batteries
as soon as possible.
Warning Level 3 (SW version 10.3 and later)
If you continue to ignore the backup battery warning, either the door can be used
50 more times or the cylinder switches off after ca. 4 weeks if there is no further
operation. In both cases, the cylinder switches into the so-called storage mode. After
this, you can only open the cylinder with the programming device.
4.2 Transponder
If the transponder battery voltage is coming to an end, eight short signal tones,
coming quickly one after another, sound each time the transponder is operated and
after the uncoupling.
(look at manual digital-locking-cylinder 3061)
& Attention: Do not take out the transponder battery because this will probably
result in the loss of data. See the “Transponder 3064” manual for more
information.