Unit installation

Transponder 3064
Page 8
4.0 Battery Replacement
4.1 Battery Replacement 3064
If a battery warning occurs, then the transponder battery can be changed at any time
(see the Manual on the 3061 Locking Cylinder – Battery warning). Open the casing
carefully so that you can see the battery. Open the battery clip and remove the
battery, insert a new one, and close the clip. Press the casing back together again.
When you change the battery it is important to ensure that the procedure does not
take more than two minutes, that the transponder button is not pressed during that
period, and that you do not short the battery – otherwise you may lose data.
Alternatively:
Send the transponder that needs its battery changing to:
SimonsVoss Technologies AG, Eichenweg 6, 07616 Petersberg.
4.2 Battery Replacement for the Explosion Protection Transponder
Attention:
Only SimonsVoss Technologies AG is permitted to change the transponder battery!
5.0 Loss of the Transponder
5.1 Emergency Opening
An emergency opening can be carried out using the SmartCD + PDA (only use
devices approved by SimonsVoss) and with the input of the locking system password.
5.2 Replacement Transponder
If a transponder is lost, it can be deleted from the locking plan and a replacement
transponder can be set up. When operating the locking system in overlay mode, the
lost transponder is automatically blocked as soon as the replacement transponder is
activated at the digital locking. (See the Software Operating Instructions Page H3 for
programming and procedure information.)