Unit installation

WAVENET RADIO NETWORK 3065
Page 25
In the LSM, virtually any number of WaveNet Ethernet routers WN.RN.E(X) or
WaveNet WLAN (W
ireless Local Area Network) routers WN.RN.W(X) can be
integrated in a customer computer network (LAN or WLAN). There is no need to
install a backbone (RS485 bus cabling), but it is possible in locations without
Ethernet/WLAN.
The WN.RN.E(X) is PoE-capable (Power over Ethernet). If you are using PoE so you
will need a midspan power supply such as Phihong PSA 16 U.
Alternatively, WN.RN.E(X) and all WN.RN.(XX) configurations can be operated with a
plug-in power supply. Æ WN.POWER.SUPPLY.PPP (not included in delivery).
The file-based LDB locking system administration software from SimonsVoss (which
is much simpler to install and easier to operate) also enables direct integration of the
transmission medium into the Intranet / Internet. To do this, a WaveNet router node is
connected to the customer’s LAN and configured using LDB or additional software
(Digi Connect) (see manual for WN.RN.E(X)). A maximum of four
WaveNet routers
can be administered in one LDB, but only one
can be activated. Æ Applies to
WN.RN.E(X) and WN.RN.W(X)
Networks are divided into segments. One WaveNet central node can operate up to
252 segments, and each segment can have up to 250 WaveNet LockNodes /
WaveNet router nodes.
Note: If you are working with the LSM software, you can also have a distribution of
2030/30 and 250/250 (segments / LockNodes per segment). During the project
planning phase you can decide whether you need more segments or more
LockNodes per segment.