Unit installation

PalmCD2 Programming Device
Page 4
been tested and approved by SimonsVoss). In this configuration, you can program all
digital components directly on the PC.
If you use the same interface (such as COM1) for both the docking station and the
PalmCD2, you need to end the HotSync manager first in order to free the serial
interface for the PalmCD2. You can set this up so that it happens automatically by
selecting the appropriate settings in the Palm user dialog box. You can also click the
symbol in the lower right of the Windows task bar and then click End.
& You can also match up your personal data with the PalmCD2 by placing your
Palm on the PalmCD2, connecting the PalmCD2 to the PC/Laptop and then
performing the HotSync process.
4.0 Programming with the Palm Organiser
Create the locking plan with the LDB locking plan software. Program the components
on the PC or laptop. When you make changes to the locking plan, the data is
transmitted to the Palm Organiser via the docking station (or PalmCD2) so that both
computers have the same data stock. Then go to each of the lockings affected by the
changes and either read them out or reprogram them from the Palm Organiser with
docked PalmCD2. Finally, transmit the new locking system status back to the PC with
a new synchronisation process. Refer to the PalmLDB operating instructions for more
detailed information.
5.0 Setting Up the PalmCD2 with Transponder Function
You can also use the PalmCD2 as a transponder in your locking system. In this case,
the HotSync key functions as the pushbutton. Refer to the chapter on special
transponders in the software operating instructions for more details.
6.0 Data Sheet
Battery type AAA 1.5 V (2x)
Dimensions 120 mm x 70 mm x 20 mm
Degree of protection IP 20