Unit installation

MANUAL - BIOMETRIC READER Q3008
Page 4
4
1.0 General information
Please take 15 minutes to read this manual and
familiarise yourself with the function of your Q3008
biometric reader.
To assemble the housing you will need a Torx key of
size TX6.
1.1 Safety information
Caution! – The battery used in this product may present a risk of fire or burns if
misused. Do not charge or open the battery. Do not heat it to over 100°C or burn it.
Do not short-circuit.
Only use batteries which have been approved by SimonsVoss.
Dispose of old and used batteries in the correct way. Keep out of the reach of
children.
Reversing the polarities may cause damage to the Q3008 biometric reader.
Do not allow the Q3008 biometric reader to become dirty or scratched. Do not drop it
or subject it to any other sudden impact.
It is essential to ensure that the device does not come into direct contact with
moisture and is not exposed to temperatures below +5°C.
The biometric reader is for indoor use only.
Master finger mode should only be used when the device is installed in a secure
indoor location and with a very small number of doors.
Program the reader as soon as it is commissioned to prevent any risk of misuse.
If the reader fails to recognise a finger, or does not recognise it correctly, this does
not necessarily mean there is a defect. SimonsVoss Technologies AG accepts no
liability for poor recognition caused by skin dryness or the physical structure of the
finger.
In order to configure a SimonsVoss biometric reader Q3008 you must be familiar with
the product and SimonsVoss software. The Q3008 biometric reader should therefore
only be programmed by trained specialists.
SimonsVoss Technologies AG shall assume no liability for damage caused by
incorrect programming.
Access through a door may be denied if a Q3008 biometric reader is incorrectly
programmed or is defective. SimonsVoss AG shall assume no liability for
consequences such as denied access to injured persons or persons at risk, damage
to property or any other form of damage.
SimonsVoss Technologies AG reserves the right to make enhancements and
modifications to the product without notice. Consequently, descriptions and