Unit installation
MANUAL - BIOMETRIC READER Q3008
Page 11
11
12. If you want the reader to learn other fingerprints, repeat from step 4. You must
first create additional transponders in the software using the biometric reader
user option (see step 1) and assign authorisations to them.
13. Bring the SmartCD into the communication range of the lock to be addressed in
situ.
14. In SmartLSM, launch the ‘Execute’ function.
15. If programming was successful, the message “Programming successful“
appears in the SmartLSM. The new biometric reader users have been
successfully stored in the lock.
16. After you import the locking plan the programming lightning symbols disappear,
both from the biometric reader user and the biometric reader (if all transponders
(biometric reader users) and the corresponding lock have been programmed).
4.0 ‘Recognize’ process
‘Recognize’ mode is the normal operation for the Q3008 biometric reader, where a
person whose fingerprint has been learned wants to open a door using a digital
locking cylinder.
Please proceed as follows:
1. When the finger is placed on the finger guide, an integrated proximity sensor
activates the biometric reader. After about 0.5 seconds, the LED flashes green.
2. You can now draw your finger (the one learned by the reader) across the sensor,
with gentle pressure, making sure that the whole of the top finger joint passes
over the sensor (refer to photos in chapter 2.2). Make sure that your finger is in
roughly the same position as when the fingerprint was learned.
3. If the fingerprint is recognised and the integrated transponder has been
successfully programmed, the LED flashes green twice and the biometric reader
is triggered.
If the LED lights up red, fingerprint recognition was not successful. If this happens,
you must start again from step 1.
If you moved your finger too quickly over the sensor, the LED gives one rapid flash in
red and then turns green again. Draw your finger across the sensor again, this time
slightly slower.
If the fingerprint is recognised, the LED will light up green. However, if the lock could
not be contacted the LED will light up red again. If this happens, start again from step
1.
Please note
:
• The Q3008 may occasionally fail to recognise a fingerprint even though it was
correctly learned.