Unit installation

MANUAL - BIOMETRIC READER Q3008

Page 16

11.0 Master finger mode

Master finger mode was developed specially for small locking systems. The biometric

reader is programmed once and fingerprints can then be learned simply on the

biometric reader itself. No distinctions can be made using different transponder IDs

(TIDs), because no TIDs are learned in master finger mode.

Generally, we recommend using SimonsVoss programming software for

programming purposes.

You can exit master finger mode at any time. To do this, all learned fingerprints

(including the master fingers) must be deleted.

Do not undertake any programming after a battery warning. Replace the battery

before proceeding. Refer to chapter 15.0 Replacing the batteryFehler! Es wurde

kein Textmarkenname vergeben.Fehler! Es wurde kein Textmarkenname

vergeben..

11.1 Commissioning – Programming master fingers

The following chapters describe in detail the programming process for master finger

mode.

Please note:

The first two fingerprints learned are automatically stored as the master

fingers. A master finger cannot also be programmed as a user finger (it will be

rejected during the learning process, indicated by 4 red flashes). Unlike normal mode,

individual fingerprints cannot be allocated a transponder ID (TID), i.e. the lock does

not make a distinction between individual users. In master finger mode it is possible

to use the biometric reader to produce an access log for all locks in the same system.

Please proceed as follows:

1. Create a locking plan in the SimonsVoss software.

2. Create ‘biometric reader’ as a lock

biometric reader.

3. Create lock (e.g. locking cylinder).

4. Connect the SmartCD to the PC and bring within communication range of the

‘biometric reader’.

5. Highlight the biometric reader and launch ‘Programming Æ Lock’ in the

programming software. This is where you undertake basic configuration of the

biometric reader.

6. If programming was successful, the programming lightning symbol disappears

from the locking plan for the relevant biometric reader.

7. Bring the SmartCD into the communication range of the lock.