Unit installation

PinCode Keypad 3068
Page 13
8.0 Resetting Transponders
8.1 Description
To reset the various transponders, please proceed as follows:
1. Press the "0" button twice.
2. Enter the master PIN.
3. Start the “Reset transponder" function n the SimonsVoss software.
4. For the particular transponder :
• Transponder 1 = press "1" button,
• Transponder 2 = press "2" button
• Transponder 3 = press "3" button
Attention:
It is not possible to enter programming mode when there is a battery
warning. This means that when the battery is weak, you cannot reset a transponder.
Programming mode will only be available again after you have successfully changed
the battery (see the section "Battery Replacement).
8.2 Procedure
Input "00"
Transpond
e
r
2 =
Transpon-
der 3 =
Function: Start "Reset transponder" in the
SV LDB
Input "00"
Transponder 1 =
p
ress "1" button
Transponder 2 =
p
ress "2" button
Transponder 3 =
p
ress "3" button
Start the "Reset transponder" function in the SV
software!!!
Input "master PIN“