Unit installation

Digital Locking Cylinder 3061 VdS
Page 3
Drilling protection
1.0 Method of Operation
1.1 General Information
The Digital Locking Cylinder 3061 VdS meets the requirements of VdS (Association
of German Property Insurers) Class B and its outer dimensions exactly match those
of a standard mechanical cylinder. In comparison to mechanical systems, it excels
because it is very easy to install, provides greater security, is more flexible and costs
less to operate. It can quickly and easily replace existing mechanical cylinders in "old
systems".
Inner knob
Outer knob
1.2 Opening and Locking From Outside
When not activated, the outer knob turns freely. It is not possible to open the door or
to lock it. Hold the transponder at a distance of approximately 10 to 40 cm (4 to 16
inches) from the digital locking cylinder and briefly press the transponder button once.
If this is an authorised transponder, a double signal tone sounds and the cylinder
couples. Now turn the outer knob in the locking or opening direction. You have
approximately five seconds for this process. You can use the software to adjust the
coupling time. The longer the coupling time, however, the shorter the service life of
the battery. Then a single signal tone sounds and the outer knob turns freely again.
Make sure that the outer knob of the locking cylinder turns freely again after the
coupling process.
& If this transponder is not authorised at this time because of the time zone plan,
a single signal tone sounds. The cylinder does not couple, however, and you
cannot open the door.
1.3 Opening and Locking From Inside
It is always possible to open doors with Digital Locking Cylinder 3061 VdS devices
from the inside without operating the transponder