Product manual

PRODUCT MANUAL
TRANSPONDER 3064
3
1 SAFETY INSTRUCTIONS
 The transponder casing is protected against splash water. However, it is not wa-
tertight!
 Only use batteries which have been approved by SimonsVoss (see Section 9)
 The batteries used in Digital Locking Cylinder 3061 may pose a fire or burn haz-
ard if handled incorrectly. Do not recharge, open, heat or burn these batteries.
Do not short-circuit.
 Dispose of old and used batteries in the proper manner and store them out of
children's reach!
 Damage may be caused to the transponder if you reverse the polarity.
 Do not touch the contacts on the new battery with your hands when replacing the
old one. We recommend using cotton gloves free of fat or grease.
 When replacing the batteries, make sure that the electronics are not subject to
mechanical load and are not damaged in any other way.
 Access through a door may be blocked due to defective or incorrectly pro-
grammed products. SimonsVoss Technologies GmbH is not liable for conse-
quences of incorrect installation, such as blocked access to injured persons or
those at risk, physical damage or any other losses. SimonsVoss Technologies
GmbH accepts no liability for damage caused by incorrect fitting or installation.
 SimonsVoss Technologies GmbH reserves the right to make changes to the
product or implement technical further developments without prior notice.
 This documentation has been compiled in accordance with the best knowledge
available to us. However, errors cannot be ruled out. No liability is accepted in
such cases.
 Should there be differences in the content of other language versions of this doc-
umentation, the German version applies in cases of doubt.