Product Description

Wireless Keypad: TRA.PINCODE
Page 10
6.2 Description
Generally to program a transponder using the SimonsVoss software you activate the
appropriate function in the software and then it directs you to press the button on the
transponder one or more times. The Wireless Keypad acts as three separate
transponders and programming them requires a little more of a procedure. To
program the various transponders with the SimonsVoss software, please follow the
procedure described in the following (also see the appropriate SimonsVoss software
manual):
1. On the Wireless Keypad, Press the "0" button twice in order to enter the
transponder programming mode.
2. Enter the "master PIN ". (you are now ready to program the Keypad)
3. Start the Transponder programming function in the SV software
4. When you are instructed to push the button on the transponder…
• Press the "1" button on the Keypad for transponder #1
• Press the "2" button on the Keypad for transponder #2
• Press the "3" button on the Keypad for transponder #3
5. Please check in the user interface to see that the programming was
successful (yellow programmer flash must have been removed in the display).
In order to be able to carry out the programming without problems, please first start
the programming command in the SV software and only then select the required
transponder using the Keypad. Otherwise it is not possible to guarantee successful
programming.
The Keypad's three integrated transponders must be located in the same lock plan as
the lock that you wish to address.
It is not possible to enter programming mode when there is a battery warning. This
means that it is not possible to change or delete transponders when there is a weak
battery. Programming mode will only be available again after you have successfully
changed the battery (see the section "Battery Replacement).