Operation Manual

IMPORTANT!
5. ELECTRICAL INSTALLATION
g. 13
Before you start the installation of the electronic parts, be sure that the battery has been disconnected to
prevent short circuits during installation.
• PlacetheECU(ascloseaspossiblenearthebattery)ontheinsideofthecaravan.Theconnectionpoints
on the ECU are clearly marked, (see g.13)Thebatterypositive+istheREDwireandnegative-isthe
 BLACKwire.
• Leadthecablesthroughthesuppliedexibleprotectionhoseandtiethemagainstthechassis.Usethe
supplied tie wraps. Be sure that the cables has been tied securely, to avoid cable damage.
• TheconnectionpointsontheECUareclearlymarked,positiveisredandnegativetheblackcable.
• Incasethemoverhasbeenttedattherearoftheaxle,themotorcableshavetobereversedartheECU.
DO NOT shorten the cables and be sure that the colors of the motor cables are together.
If wrongly connected, the electronic ECU will be destroyed immediately
21

• Placethewarningsticker“Releaserollers”nearthetowcouplingofthecaravan.
Thisinstructionmanualcanbedownloadedfromourwebsite:www.simpark.eu
• 2x6mm
2
cables, red and a brown 6 mm
2
cable. Both cables go to the battery, the red one goes to the +
pole and the brown one to the - pole of the battery.
• 2x1mm
2
cables,yellowandgreenhavetobeconnectedontheECU.Theyellowonpin9,thegreenonpin7.
• 1x1mm
2
red wire to be connected from the positive of the battery to pin 8 on the electronic ECU.
Con nect the power main switch between the RED cable of the battery as shown on the picture below.
• Thepurpleandbrowncablegoestothepoles+and-ofthecaravanconnectorsocket.(Safetyfeature).
Easymatic connections and functions
NL
UK
PIN7-GREEN
PIN9-YELLOW
BLUE
GREEN
BROWN
RED
YELLOW
PIN6-PURPLE TOPIN9OFTHE
TOWHOOKSOCKET
TOPIN13OFTHE
TOWHOOKSOCKET
PIN8-RED
PIN5-BROWN
BROWN
GROUND
12VOLT
Hydraulic pump
Main switch
Battery