Installation Guide

ManualsBrandsSimple Project ManualsBath19 in. Rear Drain Toilet 0.8/1.28 GPF Double Flush Round in White, with Soft Closing Seat

REAR OUTLET TOILET

BEFORE INSTALLING

Read entire Rear Outlet Toilet Installation

Instructions. Observe all local building and

safety codes.

INSTALLATION

1. If you are installing a two-piece toilet, slide the tank bolts

through the mounting holes on the top ofthe base of the

toilet and thread the washers and nuts onto the tank bolts.

Verify that the tank is level and alternately tighten the

washers and nuts until the tank is resting ﬁrmly on the bowl.

Ifyour toilet is one piece only, move on to the nextstep.

2. Place the toilet in the location where it will be installed.

3. Measure the distance from the back ofthe waste outlet

on the toilet to the wall hub ﬁtting to determine the length

ofthe p-trap connector. The connector should extend

approximately 1-1/2" into the hub ﬁtting.

INSTRUCTIONS

For the following installation instructions for a

new toilet, it is assumed that all old fixtures

have been removed and the toilet flange is in

the new toilet.

Unpack and inspect the product for any

shipping damage. Do not install if found

damaged. Please contact customer service. If

you need help or have questions about

installing your toilet, please contact Customer

Service.

If you are new to bathroom fixture

installation, we recommend that you consult

a professional. We are not responsible for

any damage to floors, walls, pipes or

personal injury during installation.

TOOLS AND MATERIALS:

Pencil

Hacksaw

Level

PVC Glue

Drill

Adjustable

Wrench

Summary of content (3 pages)

PAGE 1
REAR OUTLET TOILET BEFORE INSTALLING INSTALLATION INSTRUCTIONS 1. If you are installing a two-piece toilet, slide the tank bolts through the mounting holes on the top of the base of the toilet and thread the washers and nuts onto the tank bolts. Verify that the tank is level and alternately tighten the washers and nuts until the tank is resting ﬁrmly on the bowl. If your toilet is one piece only, move on to the nextstep. Read entire Rear Outlet Toilet Installation Instructions.
PAGE 2
INSTALLATION (STEPS 4-9) 4. Trim the p-trap adapter with a hacksaw to the appropriate length as necessary. 7. Apply PVC or ABS glue around the p-trap connector and place inside the hub ﬁtting. 8. Slide the toilet into place and press the waste outlet into the p-trap connector. 5. Mark the location of the pre-drilled mounting holes using the holes in the base of the toilet as a template. 6. Remove the toilet from the work area and drill mounting holes in the locations designated in the previous step. 9.
PAGE 3
INSTALLATION (STEPS 10-13) 10. Place caps over the anchor bolts on the base of the toilet. 13. Finish your installation by applying latex caulk or tile grout around the base of the toilet. This will ﬁnish the joint between your ﬂoor and toilet bowland divert water away from the base of the toilet. 11. Connect the water supply tubes at the bottom of the tank. Turn on the water supply and ﬂush the toilet several times to check for any leaks around the back or base. 12. Attach the toilet seat.