Installation Guide

INSTALLATION (STEPS 4-9)
4. Trim the p-trap adapter with a hacksaw to the
appropriate length as necessary.
5. Mark the location of the pre-drilled mounting holes
using the holes in the base ofthe toilet as a template.
6. Remove the toilet from the work area and drill
mounting holes in the locations designated in the
previous step.
7. Apply PVC or ABS glue around the p-trap connector
and place inside the hub fitting.
8. Slide the toilet into place and press the waste outlet
into the p-trap connector.
9. Once the toilet is securely in place, insert anchor bolts
and washers through the mounting holes in the base of
the toilet and tighten into the pre-drilled holes created
instep 6.