User manual

2.3 Default Settings

The factory default settings are presented below.

• Authentication password = paterna

• Factory Reset password = betera

• Factory Reset time = 10 seconds

• IP Configuration = FIXED

• FIXED IP address = 192.168.1.100

• FIXED IP subnet mask = 255.255.255.0

• Default Gateway IP address = 192.168.1.105

• DNS Server IP address = 192.168.10.252

• Network Identifier = Serial Number of AP Unit

• Encryption Key = This field is empty

• Encryption Type = 3DES (168-bit)

• Automatic Multicast = Disabled

• IGMP Aware Multicast = Disabled

• MLD Aware Multicast Syndication = Disabled

• Video Optimization = Automatic

• Priority (QoS) Configuration = UDP Priority 5, TCP Priority 0 (Default=4)

• VLAN Configuration = Disabled

• PHY – Notches = Enabled

• PHY – Power Control = Enabled

• Power Saving = Enabled (300 second delay)

• Link Layer Topology Discovery (LLTD) = Enabled

NOTE: These configuration settings can be customized using a web browser.

For further instructions, see Chapter 5 - Web User Interface. To return

the adapter to factory default settings, follow the FACTORY RESET

procedure in the Troubleshooting section of this manual.