User manual

200M PLC User Manual 5 How to Use the Utility Software
14
Device Name
This field shows the default device name. You can change the
name by either clicking Rename or clicking the name and editing
the name.
MAC Address
This field shows the MAC address of the remote device.
Password
By default, this field is blank. You can click Enter Password and
enter the password.
To set the Password of the device (required when creating a
private network), click the device name in the lower panel to select
the device, and click Enter Password. A dialog box appears as
shown in Figure 7to enter the password. The selected device name
is shown above the password field and you can verify the password
by clicking OK. The Password field accepts the Device password
in any case format, with or without dashed between them.
A confirmation box appears if the password is entered correctly. If
a device is not found, you are notified along with the suggestions to
resolve common problems. This process might take a few seconds.