System information

78
AS/400 IBM Network Station: Techniques for Deployment in a WAN
2. Power on the IBM Network Station. The IBM logo is shown, followed by a
memory and keyboard check.
3. After the message
NS0500 Search for Host System is shown, press
ESC
to stop the start-up sequence.
4. Start the IBM Network Station Boot Monitor program by pressing the
following sequence of keys:
• For 101/102 keyboards:
Press and hold
Left Shift + Left Alt + Left Ctrl.
Press
F1
.
• For 5250/3270 keyboards:
Press and hold
Left Shift + Left Alt
. Press
F1
.
5. Enter
NV
at the Boot Monitor prompt (>) to access the NVRAM utility.
6. Enter
L
to reset the NVRAM.
7. Enter
S
to save the defaults into NVRAM.
8. Enter
Y
to the question
Are you sure?
9. Enter
Q
to quit.
10.Enter
SE
(or press F1) from the boot monitor prompt to start the
IBM
Network Station Setup Utility
.
11.Press
PF3
(
Set Network Parameters).
12.The Network parameters should default to Network after the reset. To
change the
IP Addressed from field from Network to
NVRAM
, use the right
arrow key.
13.Enter the
Network Station IP address . In this scenario, the IP address of
the Network Station is
10.1.1.10
.
14.Enter
The First Boot Host IP address of
10.1.1.2
. This is the AS/400
system that contains the Flash card image that you want to test.
15.Enter
The First Configuration Host IP address of
10.1.1.2
. This is the
same AS/400 system that contains the Flash card image.
If prompted for an administrator password, enter it now. This is the
password an administrator sets using the IBM Network Station Manager
program.
Note