Specifications

Section 4: Telephones and Optional Equipment
Aspire S Hardware Manual Section 4: Telephones and Optional Equipment ◆ 4-33
4
4. If using the mono audio jack to connect to the recorder or audio input, plug the audio jack into the
REC connector on the ADA and then skip to Step 9. If wiring directly to the terminals inside the
adapter, remove the screw on the back of the adapter. Using a small screwdriver, push the ribs on
the sides of the adapter in and remove the cover.
Do not push the ribs in too much or they may break.
Figure 4-25: REMOVE THE SCREW FROM THE ADA ADAPTER
5. Determine which terminals should be connected. Terminals T3 and T4 are used for wiring to a
recorder.
T6 and T7 are used to activate a relay. T his relay will turn on a recorder when a call is placed
ore received. The dip switch “1” must be set to the “on” position.
6. Run the cable to the ADA adapter through the opening near the audio jac.
Figure 4-26: RUNNING THE CABLE TO THE ADA
7. Insert the cable into the terminal. Place the cap over the terminal and push down to secure the cable.
Figure 4-27: WIRING TO THE ADA TERMINAL
0893100 - 67
Remove screw
ADA Module
0893100 - 68
0893100 - 66
Cap
Cable