Specifications

Section 4: Telephones and Optional Equipment
4-36 ◆ Section 4: Telephones and Optional Equipment Aspire S Hardware Manual
4. If using the mono audio jack to connect to the recorder or audio input, plug the audio jack into the
REC connector on the ADA2 and then skip to Step 9. If wiring directly to the terminals inside the
adapter, remove the screw on the back of the adapter. Using a small screwdriver, push the ribs on
the sides of the adapter in and remove the cover.
Do not push the ribs in too much or they may break.
Figure 4-33: REMOVE THE SCREW FROM THE ADA2 ADAPTER
5. Determine which terminals should be connected. Terminals T3 and T4 are used for wiring to a
recorder.
T6 and T7 are used to activate a relay. T his relay will turn on a recorder when a call is placed
ore received. The dip switch “1” must be set to the “on” position.
6. Run the cable to the ADA2 adapter through the opening near the audio jack.
Figure 4-34: RUNNING THE CABLE TO THE ADA2
7. Insert the cable into the terminal. Place the cap over the terminal and push down to secure the cable.
Figure 4-35: WIRING TO THE ADA2 TERMINAL
0893100 - 67
Remove screw
ADA Module
0893100 - 68
0893100 - 66
Cap
Cable