Datasheet

12 Zeus 2.5-Inch ATA Solid State Drive
Data Transfer Rates
The data transfer rate varies according to the flash controller/flash memory configuration of the drive.
The scalable architecture of the drive is capable of accommodating sustained and burst data transfer
rates as listed in Table 2.
Table 2. Data Transfer Rates
Purge Times
The time required to purge a Zeus SSD depends on the actual purge option invoked by the user and
the flash controller/flash memory configuration of the drive. A list of representative purge times is
listed in Table 3, with the value expressed in seconds per 32 Gigabytes (sec/32GB) for each purge
option.
Table 3. Purge Times
Repairs
A defective SSD should be replaced. There are no parts, assemblies or subassemblies that can be
repaired individually by the user. Please see the section titled Certification and Warranty on the
inside of the back cover page. Unauthorized repairs to the SSD will void the warranty.
Preventative Maintenance
No preventative maintenance is required. The SSD unit is sealed at the factory, and there are no
parts, assemblies, or subassemblies that require preventative maintenance on behalf of the user.
Please see the section titled Certification and Warranty on the inside of the back cover page.
Unauthorized maintenance to the SSD will void the warranty.
Parameter Value Units
Average Access 0.3 m/sec
Average Latency 0.3 m/sec
Sustained Read 40 Megabytes/sec
Sustained Write 26 Megabytes/sec
Burst Read 66 Megabytes/sec
Burst Write 66 Megabytes/sec
Purge Option Value Units
BasicPurge 360 sec/32GB
RapidPurge 9 sec/32GB
MilPurge 1,200 sec/32GB
Intelligent Destructive Purge 2 sec/32GB