Operator`s manual

9-3
Follow these steps to display software revision information.
1. Press the MENU key.
2. Press the <NEXT> or <PREVIOUS> keys until the prompt reads, ―Display Software
Revision Level?‖
3. Press <ENTER>. A display similar to the following appears.
4. Interpret this information as follows.
 SYS REV: Specifies the revision of the executive software (operating system of the
FIP) loaded in the panel.
 CFIG FORMAT: Defines the compatibility of the executive and the programmer.
 JOB: Specifies the name of the job loaded in the panel.
 REV: Specifies the revision of the job.
 DATE: Specifies the date on which the revision was built in the programmer.
Displaying Software Revision
Overview
SYS REV: 11.02.08 CFIG FORMAT: 112
JOB: JOB1 REV:6 13-OCT-00