Installation manual

11 of 72
SIMPLEX Fault Assistance Guide RevA
29 April 2009
1.1.2.1 Card Missing/Failed
Description:
The circuit card is not communicating correctly with the panel controller.
Possible causes:
 Card has not been fitted
 Card is not seated correctly on connector
- Power down panel, clean connectors and reinsert
 Card has not been addressed correctly
 Card baud rate incorrectly set (Dipswitch 1 always in ON position)
 Another card has been addressed the same as this card
 Card has failed
1.1.2.2 Correct Card Abnormal
Description:
The wrong type of card has been addressed at this location.
Possible causes:
 Incorrect card fitted in the panel.
 Two cards have the same address.