Installation manual

- 36 -
36 of 72
SIMPLEX Fault Assistance Guide RevA
29 April 2009
3.1 Identifying Faults on the IMS – General
Instructions
3.1.1 IMS & TrueSite Workstation Graphical Control Centre
All current faults on a network can be viewed from the Graphical Control Centre (setup is site
specific). It is possible to access a panel directly from the Graphical Control Centre using the
Set Host function on an IMS System or by opening a session in Terminal Mode on the Network
tab on a TrueSite Workstation.
For assistance on utilising these features please refer to the corresponding User Manual that is
supplied with each system.
Acknowledge fault condition
by clicking the yellow button in
top right corner, highlight
flashin
g
fault and
p
ress
Check description of fault and compare
it to the fault list sheet.
Follow the instructions specified for that
s
p
ecific fault.
Finished
Fault buzzer
sounds on
IMS.