Installation manual

- 59 -
59 of 72
SIMPLEX Fault Assistance Guide RevA
29 April 2009
5.4.4 STBM9008 Board Installation
To install the STBM9008 Module, perform the following steps:
STEP 1
: Install the STBM9008 board into the DIN rail housing and install the
unit on the DIN rail.
STEP 2
: Isolate power to the SYSTEM by Switching OFF ALL the DC circuit
breakers on the power supply unit.
STEP 3
: Install all the cable connections to the STBM9008 module and ensure
that the DIP switch has been set to the correct settings.
STEP 4
: Switch on the DC circuit breakers and check that the system
functions correctly.