Installation manual

SIMPLEX 4100 FIRE INDICATOR PANEL Page 13
OPERATOR MANUAL
Document No: 4100-M001 May 1997 Issue 1.0
WARNING
If the zone is still in alarm, a WARNING is displayed which tells you that the
system will sound an alarm if the timer (60 seconds) times out. TO ABORT THE
ENABLE, PRESS THE <DISABLE> KEY. If an alarm condition exists, the
following is shown on the display.
**WARNING** Press <DISABLE> to abort
M1-1 will ALARM in 60 seconds
IF THE ABOVE WARNING IS SHOWN ON THE DISPLAY, PRESS THE
<DISABLE> OR AN <ACK> KEY. FAILURE TO ABORT THE ENABLE WILL
CAUSE AN ALARM CONDITION, CALL THE FIRE BRIGADE AND PUT THE
BUILDING INTO FIRE MODE
If the enable process is successful, the following message is shown on the display:
ENABLE COMPLETED
4. Repeat steps 1 through 3 above to ENABLE the required points.