Installation manual

Page 30 SIMPLEX 4100 FIRE INDICATOR PANEL
OPERATOR MANUAL
Document No.: 4100-M001 May 1997 Issue 1.0
5.11 VIEWING THE HISTORICAL ALARM AND FAULT LOGS
The Historical Alarm and Fault Logs can be viewed either from the 4100 Operator
Panel or from the CRT Terminal . This section describes accessing the Historical
Logs from the 4100 FIP, refer to CRT Operator Manual for CRT Terminal operation.
1 Press the <MENU> key on the DISPLAY/ACTION keypad.
2. Using the <NEXT> and <PREVIOUS> keys on the DISPLAY/ACTION keypad,
scroll through the Main Menu items until the "Display Historical Alarm Log?" or
"Display Historical Fault Log?" menu prompt appears on the alphanumeric
display.
3. Press the <ENTER> key on the ENTRY keypad.
4. Using the <NEXT> and <PREVIOUS> keys on the DISPLAY/ACTION keypad
scroll through the list of logged events, until the desired event is shown on the
display.
NOTE: Pressing the <PREVIOUS> key first, causes the most recent event to
be displayed.
5. When finished, press the <CLR> key on the ENTRY keypad to escape from the
main menu.
5.12 OPERATOR LOG IN/LOG OUT PROCEDURES
Various functions may be passcode protected to prevent access by unauthorised
personnel. Passcodes are provided to the user during system installation. To change
or receive additional information concerning your passcodes, contact your local
Simplex Branch Office.
5.12.1 Access Level Log-In Procedure
To Log on, perform the following procedure.
1. Obtain the appropriate passcode information.
2. Open the interface panel access door.
3. Press the <MENU> key on the DISPLAY/ACTION keypad on the right side of
the interface panel. The following is displayed.
Press <NEXT> or <PREVIOUS> to scroll
Change Access Level?