User manual
High Pressure Washer
5
Read entire Owners manual before you attempt to
assemble or operate your new pressure washer.
Your new pressure washer has been assembled at
the factory with exception of those parts left unassem-
bled for shipping purposes.
REMOVE PRESSURE
WASHER FROM CARTON
Remove parts box included with pressure washer.
Slice two corners at guide handle end of carton
from top to bottom so the panel can be folded down
flat, then remove all packing material.
Roll pressure washer out of carton.
CARTON CONTENTS
Items in the carton include:
Main Unit
Parts Box (which includes the following):
Wireform
Goggles
Nozzle Cleaning Kit
Owners Manual
Engine Manual
Spray Gun
Nozzle Extension
High Pressure Hose
Handle
Parts Bag (which includes the following):
1 carriage bolt
1 carriage hook
2 knobs
If any of the above parts are missing or damaged, call
the pressure washer helpline at 18002701408.
PREPARING THE PRESSURE
WASHER FOR USE
If have any problems with the assembly of your pres-
sure washer or if parts are missing or damaged, call
the Pressure Washer Helpline at 1-800-270-1408.
To prepare your pressure washer for operation you
will need to perform these tasks:
Attach the Handle and attach the wire form that
holds high pressure hose and spray gun.
Connect high pressure hose to the spray gun and
the pump and connect water supply to the pump.
Add oil to engine crankcase.
Add fuel to fuel tank.
Attach the Handle
Place the top of the handle onto the bottom of the
handle already connected to the main unit making
sure the holes in the top align with the holes on the
bottom.
Insert the carriage bolt through the left hole (looking
at the back of the pressure washer) as shown in
Figure 2 and attach a plastic knob. Tighten the
knob by hand.
Insert the carriage hook through the right hole. Pull
the recoil handle out slowly. Place the recoil string
through the hook and attach the plastic knob.
Tighten the knob by hand.
Generac 1750PSI High Pressure Washer
AA
SSSSEEMMBBLL
YY
GENERAC
Figure 1 — Attach the top of the handle to the
bottom of the handle.
Figure 2 — Insert the carriage bolts and attach
the knobs.
Make sure the
holes on the
top of the
handle are
aligned with the
holes in the
bottom of the
handle