User manual
12
Generac Portable Products 2000 PSI High Pressure Washer
Applying Detergent with the
Adjustable Nozzle
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could
damage the pump.
IMPORTANT: You must attach all hoses before you
start the engine. Starting the engine without all the
hoses connected and without the water turned ON will
damage the pump.
To apply detergent follow these steps:
Review the use of adjustable nozzles on Page 11.
Prepare the detergent solution as instructed.
Hang the detergent solution on hook of the wireform
on the handle as shown (Figure 13).
Place small filter end of the chemical injecting tube
into the detergent container (Figure 13).
Slide the adjustable nozzle forward to low pressure
mode. Detergent cannot be applied with nozzle in
high pressure position.
IMPORTANT: Detergent cannot be applied without
the water source turned on.
Make sure garden hose is connected to water inlet.
Check that high pressure hose is connected to
spray gun and pump, and start engine.
Apply detergent to a dry surface, starting from the
bottom and working up to avoid streaking.
Allow the detergent to soak in for 35 minutes
before washing and rinsing. Reapply if necessary to
prevent drying.
For washing, start at lower portion of area to be
washed and work upward, using long, even,
overlapping strokes.
CAUTION! Keep the plastic injector tube from
coming in contact with the hot muffler. When
inserting the filter into a cleaning agent bottle,
route the tube so as to keep it from
inadvertently contacting the hot muffler.
Note: After using chemical injection, you must flush
the hose and the pump with clear water to prevent
chemicals from drying and clogging the chemical
injection system. See Cleaning Chemical Injector
System on page 14.
Pressure Washer Rinsing
WARNING! Be extremely careful if you must
use the pressure washer from a ladder,
scaffolding or any other unstable location.
Pressure in a running washer builds as you
climb. When you press the trigger, the recoil
from the initial spray could force you to fall.
The high pressure spray is also dangerous if
you are too close to the cleaning surface.
For Rinsing:
Slide nozzle backward to high pressure, squeeze
trigger and wait for detergent to clear.
Keep the spray gun a safe distance from the area
you plan to spray.
Apply a high pressure spray to a small area and
then check the surface for damage. If no damage is
found, you can assume it is okay to continue
cleaning.
Start at top of area to be rinsed, working down with
the same overlapping strokes used for cleaning.
Note: You can also stop detergent from flowing by
simply removing siphon from bottle.
Automatic Cool Down System
(also called Thermal Relief)
If you run the engine on your pressure washer for 35
minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach a temperature
between 140145°F. When the water reaches this
temperature, the automatic cool down system
engages and cools the pump by discharging the
warm water onto the ground. This system prevents
internal damage to the pump.
Figure 13 Insert the small filter into container of
cleaning solution.