User manual

7
Generac Portable Products 2000 PSI High Pressure WasherGenerac Portable Products 2000 PSI High Pressure Washer
 Insert the carriage bolt through the right hole
(looking at the front of the pressure washer) and
attach a plastic knob. Tighten the knob by hand
(Figure 2).
 Insert the carriage hook through the left hole
(looking at the front of the pressure washer). Pull
the recoil handle out slowly. Place the recoil string
through the hook and attach the plastic knob.
Tighten the knob by hand (Figure 2).

Insert the wire form with the longer arm positioned on
the left. From this view (from rear of unit) the hook
should resemble a J
(Figure 3) .
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
Note: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF,SG, SH or SH/CD rated SAE 30
weight.
Select the oils viscosity grade according to your
expected operating temperature:
Do Not Use SAE 10W40 Oil.
Although multiviscosity oils (5W30, 10W30, etc.)
improve starting in cold weather, these multiviscosity
oils will result in increased oil consumption when used
above 32°F. Check your engine oil level more
frequently to avoid possible damage from running low
on oil.
 Place pressure washer on a level surface.
 Clean area around oil fill and remove oil dipstick
(Figure 4).
 Wipe dipstick clean. Pour oil into oil fill opening until
oil reaches FULL mark on the dipstick. Stop
occasionally to check oil level. DO NOT OVERFILL.
 Install oil dipstick, hand tighten securely.
Note: Check Oil Often During Engine Breakin.
Figure 3  Fit wire form on handle.
Figure 4  Add oil to engine crankcase. Do not attempt
to start engine without adding oil.
Oil Fill Cap
Figure 2  Insert the carriage bolt and hook and attach
the knobs.
colder 32°F warmer
5W30 SAE 30