User manual

8
Generac Portable Products 2000 PSI High Pressure Washer
Add Gasoline
DANGER! Never fill fuel tank indoors. Never
fill fuel tank when engine is running or hot. Do
not smoke when filling fuel tank.
WARNING! Never fill fuel tank completely
full. Fill tank to about 1/2" below the bottom of
the filler neck to provide space for fuel
expansion. Wipe away any fuel spillage from
engine and equipment before starting.
The manufacturer recommends fresh, clean unleaded
automotive gasoline.
 Use clean fuel and store in approved, clean,
covered containers. Use clean fill funnels. Never
use stale gasoline left over from last season or
gasoline stored for long periods.
 Clean area around fuel fill cap, remove cap.
(Figure 5).
 Add UNLEADED regular gasoline, slowly, to fuel
tank. Use a funnel to prevent spillage.
 Install fuel cap and wipe up any spilled gasoline.
Connect Hose and Water Supply
to Pump
IMPORTANT: You must assemble wand and attach
all hoses before you start engine. Starting engine
without all hoses connected and water supplied will
damage pump.
 Uncoil high pressure hose and attach one end of
hose to the base of the spray gun (Figure 6).
Tighten by hand.
 Attach other end of high pressure hose to the high
pressure outlet on the pump (Figure 7). Tighten by
hand.
 Before you connect your garden hose to the water
inlet, inspect the Inlet Screen (Figure 8). Clean the
screen if it contains debris or have it replaced if
damaged. Do not run the pressure washer if the
inlet screen is damaged.
 Connect garden hose to water inlet. Tighten by
hand (Figure 8).
Figure 7  Connect high pressure hose to pump.
Figure 6  Connect high pressure hose to spray gun.
Figure 5  Add gasoline to fuel tank.
Fuel Cap