User manual
10
Generac Portable Products 1300 PSI Pressure Washer
Attach bottle onto foamer making sure the bottle
hangs down.
Start washer and apply detergent to a dry surface,
starting from the bottom and working up.
To rinse, YOU MUST, stop the pressure washer,
remove the foamer and connect the adjustable
nozzle extension.
Note Detergents are most effective applied to a dry
surface.
How to Use the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern. The high pressure spray is most
effective when the tip of the wand is held between 8 to
24 inches from the surface being cleaned.
Always start the turbo nozzle at a distance, gradually
getting closer to the surface until you get the cleaning
force you want.
CAUTION! The turbo nozzle produces an
extremely high pressure spray which is capable
of removing paint and cutting holes through
surfaces if held too close. Always make sure
the surface you will clean will not be damaged
by the high pressure spray by testing in a
hidden area.
Note: You cannot apply detergent with the turbo
nozzle.
How to Use the Utility Brush
The utility brush allows you to scrub surfaces with
water filtering through the bristles.
To attach the utility brush to the gun:
Attach the bayonet adapter to the base of the brush.
Tighten.
Remove the turbo nozzle extension from the gun if
attached.
Attach the brush with the bayonet adapter to the
spray gun by aligning the locking tabs on the
adapter with the grooves in the gun. Push the brush
inward and twist clockwise to lock in place.
Note: You must use the bayonet adapter to attach the
brush to the gun.
To Clean
Start at lower portion of area to be washed and work
upward, using long, even overlapping strokes.
Detergent or degreaser works best when you apply it
to a dry surface first. Let it set for 35 minutes before
washing and rinsing.
Rinse
Start at the top of area to be rinsed, working down with
the same action as for cleaning.
Figure 10 Connecting the Foamer