User manual

6
Generac Portable Products 1300 PSI Pressure Washer
CARTON CONTENTS
Items in the carton include:
 Main Unit
 Cart Base
 Cart Box (which includes hardware to assemble the
cart)
 Parts Box (which includes the following):
 Goggles
 Owners Manual
 Spray Gun
 Turbo Nozzle with Extension
 Foamer
 High Pressure Hose
 Utility Brush
 Parts Bag (which includes the following)
 Nozzle Cleaning Kit
 Bayonet Adapter, must be used to attach the
utility brush to the gun.
 QuickConnect (male and female ends)
Refer to the above list for an illustrated listing of all
items included with your pressure washer. Become
familiar with each piece before assembling the
pressure washer. Check all contents against list. If any
parts are missing, call the pressure washer helpline at
18002701408.
CART ASSEMBLY AND
INSTALLATION
To assemble your cart you need the following
tools:
 Hammer
 Adjustable Wrench
 Phillips Screwdriver
 Wood Block
Assemble Cart as follows:
1. Place wood block (not supplied) on hard surface.
2. Place axle (Item 6) on wood block and tap axle
cap (Item 3) onto axle.
3. Install wheel (Item 4) on axle with raised hub away
from axle cap. Install axle spacer (item 5) and
insert axle through mounting holes on cart base.
4. Turn cart base on its side, resting axle cap on
wood block.
5. Install axle spacer (Item 5) and then wheel (Item
4) on axle with raised hub toward cart base. Tap
axle cap (Item 3) onto axle.
6. Attach cart handle (Item 10) using one carriage
bolt (Item 7) and one knob (Item 8) on both sides
of handle.
7. Slide two T-Head bolts (Item 11) into slots on
bottom of pressure washer unit.
8. Align bolts on pressure washer to holes on cart
base. Tighten to cart base with nuts (Item 2).
9. Insert wire frame accessory holder (Item 9) into
cart handle as shown.
Figure 1  Assemble the Cart