User manual

8
Generac Portable Products 1300 PSI Pressure Washer
DANGER! When connecting the unit to a
power supply receptacle, use ONLY a
receptacle protected by a Ground Fault Circuit
Interrupter (GFCI). This will help protect against
electrical shock.
CAUTION! Before starting you should be sure
the electrical supply is rated at 120 volts, 15
amps.
WARNING! To reduce the risk of
electrocution, keep ALL connections dry and off
the ground. DO NOT touch plug with wet
hands.
HOW TO OPERATE YOUR
PRESSURE WASHER
Note: We do not recommend that you use extension
cords with this pressure washer. If, however, your
application requires that you need an extension cord,
use only extension cords that are approved for outside
use. These extension cords are identified by a marking
ACCEPTABLE FOR USE WITH OUTDOOR
APPLIANCES; STORE INDOORS WHILE NOT IN
USE. Use only extension cords having an electrical
rating not less than the rating of the product. Do not
use damaged extension cords.
 Turn on the water.
NOTE: Inlet water temperature should not exceed
104°F.
 Squeeze trigger to purge pump of system air and
impurities.
 Attach the turbo nozzle extension to spray gun by
aligning the locking tabs on the extension with the
grooves in the gun. Push extension inward and twist
clockwise to lock in place (Figure 6).
 Press the master On/Off Switch to the On position
(Figure 7).
DANGER! You must be careful at this point.
Anytime you squeeze the trigger, the motor will
start and water will spray out of the gun.
DANGER! You must attach the spray gun and
all hoses before you start the motor.
WARNING! Before starting the pressure
washer, be sure you are wearing adequate eye
protection. Goggles are included with this unit.
Figure 6  Connect the Turbo Nozzle Extension to the
Spray Gun
Figure 7  Press the Master On/Off Switch to the On
Position