User manual

12 BRIGGSandSTRATTON.COM
How to Stop Your Pressure Washer
1. Release spray gun trigger and let engine idle for
two minutes.
2. Push engine stop switch to OFF (0) position.
3. ALWAYS point gun in a safe direction and press
red button and squeeze spray gun trigger to
release retained high water pressure.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places
to store your spray gun, nozzle extension and high
pressure hose.
1. Place nozzle extension through hole on accessory
tray, as shown.
2. Place spray gun through hole on accessory tray
on left side of unit.
3. Hang high pressure hose on hook as shown.
How to Use Spray Tips
The quick–connect on the nozzle extension allows you
to switch between three dierent quick connect spray
tips. Spray tips can be changed while pressure washer
is running once spray gun trigger lock is engaged. The
spray tips vary the spray pattern as shown.
Follow these instructions to change spray tips:
1. Pull back collar on quick–connect and pull current
spray tip o. Store spray tips in holder provided on
the nozzle extension.
2. Select desired spray tip:
For gentle rinse, select green 25° spray tip.
To scour surface, select red 0° spray tip.
To apply detergent, select black spray tip.
3. Pull back on collar, insert new spray tip and
release collar. Tug on spray tip to make sure it is
securely in place.
Usage Tips
For most eective cleaning, keep spray tip from
20 to 61 cm (8 to 24 in.) away from cleaning
surface.
If you get spray tip too close, especially using a
high pressure spray tip, you may damage surface
being cleaned.
DO NOT get closer than 15 cm (6 inches) when
cleaning tires.
Black Use to
apply detergent
25° Green 0° Red
Low Pressure
High Pressure
WARNING The high pressure stream of water
that this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected, which
could result in serious injury.
Keep high pressure hose connected to pump and spray
gun while system is pressurized.
ALWAYS point spray gun in safe direction, press red
button and squeeze spray gun trigger to release high
pressure, every time you stop engine.
WARNING The high pressure stream of water
that this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
amputation.
NEVER exchange spray tips without the trigger lock
being engaged on the spray gun.
DO NOT twist spray tips while spraying.