User manual

6 BRIGGSandSTRATTON.COM
Assembly
Read entire operator’s manual before you
attempt to assemble or operate your new
pressure washer.
Your pressure washer requires some assembly and is
ready for use after it has been properly serviced with
the recommended oil and fuel.
If you have any problems with the assembly of your
pressure washer, please call the pressure washer
helpline at 1-300-BRIGGS (274.447). If calling for
assistance, please have the model, revision, and serial
number from the identication label available.
Unpack Pressure Washer
1. Remove the parts bag, accessories, and inserts
included with pressure washer.
2. Open carton completely by cutting each corner
from top to bottom.
3. Ensure you have all included items prior to
assembly.
Items in the carton include:
• Main Unit
• Handle
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect and Spray
Tip Holder
• Accessory Storage Tray
• Parts Bag (which includes the following):
• Operator’s Manual
• Garden Hose Adapter
• Ba g containing 3 Multi–Colored Spray Tips
• Handle Fastening Hardware Kit (which
includes):
• Carriage Bolts (2)
• Plastic Knobs (2)
• Tree Clips (2)
To prepare your pressure washer for operation,
you will need to perform these tasks:
1. Attach handle and accessory tray to main unit.
2. Add oil to engine crankcase.
3. Add fuel to fuel tank.
4. Connect high pressure hose to spray gun and
pump.
5. Connect water supply to pump.
6. Attach nozzle extension to spray gun.
7. Select/attach quick connect spray tip to nozzle
extension.
Attach Handle and Accessory Tray
1. Place handle (A) onto base (B). Make sure holes
in handle align with holes on base.
2. Insert carriage bolts (C) through holes from
outside of unit and attach a plastic knob (D) from
inside of unit. Tighten by hand.
3. Place accessory tray (E) over base (F) (viewing
from rear of unit). Make sure holes in accessory
tray align with holes on base. Push tree clips (G)
into holes until they sit at against accessory tray.
4. Insert supplied accessories in spaces provided in
accessory tray. See How to Use Accessory Tray.
Add Engine Oil
1. Place pressure washer on a at, level surface.
2. Clean area around oil ll and remove yellow oil ll
cap/dipstick.
3. Slowly pour engine oil into oil ll opening.
Checking oil level frequently, ll to FULL mark (top
hole) on dipstick.
NOTICE Pause to permit oil to settle. Wipe dipstick
clean each time oil level is checked. DO NOT overll.
D
A
B
C
C
G
F
E
Full
Add